Skip to content

The power wire — check the plug first

Some cars need nothing but a plug-in. Some need one wire added. The difference isn’t the cluster — it’s the harness in the car.

Pull the factory cluster and turn it over. Look at the wires going into the plug.

There’s a single wire sitting in the harness — the car already feeds the cluster, so it plugs straight in and you’re done.

That wire isn’t there — nothing powers the cluster, and you add one.

The factory harness already has this power wire
The wire is there. Plug in, no modification at all
The factory harness is missing this power wire
The wire is missing. You add one

That one wire is the whole difference. Everything else on the plug is identical.

One end into the plug, one end into the fuse box.

Power wire with a crimped terminal going into the empty cavity
Crimp the terminal, push it into the empty cavity, all the way in
Taking power at the fuse box in the driver's footwell, lower left
The other end runs to the fuse box in the driver’s footwell, lower left, and takes power through a fuse tap
  1. Crimp a terminal on one end, push it into the empty cavity until it seats, then tug lightly to confirm it’s locked.
  2. Run the other end to the fuse box in the lower left of the driver’s footwell and take power from a spare slot with a fuse tap. Don’t strip another harness and splice onto it.
  3. Meter it before you power up, confirm the voltage, then plug the cluster in.

Full install order: Installation & wiring.